CAM-330

Someone has walked into the red zone around the valve skid

Mid-morning in the process unit. The floor carries a red painted enclosure with white stripes: it marks the radius around the valve skid, and nobody steps inside without a permit. A worker in blue coveralls and a white hard hat is walking straight through it, toward the equipment. Outside, two colleagues in yellow vests are talking on the radio and never see him. The camera sees the paint on the floor, and sees that someone has stepped on it.

CAM-330 · VALVE SKID · RED ZONE ENTRY

What IRIS understands

What it recognizes in this scene

person inside the red zone
red enclosure around the skid
valve skid
colleagues outside the enclosure
windsock

What this camera measures

An alert says something’s happening. The reading says how much.

38 sTime inside the zone
1People inside
3People outside
6 mFeet to the painted edge
10:41Time of the alert

The figures on this screen are an example from the illustration, not any client’s measurement.

The rule

You decide once. IRIS applies it always.

a person enters the red enclosure around the skid and is still inside after a few seconds

Then

open the alert with the camera, the time and the video of the entry
send it to the shift radio and to the control room
keep the video clip for the work permit review

The instruction that set it up«Tell me if someone walks into the red zone around the valve skid and stays there.»

What changes

What changes for whoever answers for the plant

Whoever runs the plant finds out while the person is still inside, not when someone mentions it the next day. The alert arrives with the camera, the time and the video of the moment the painted line was crossed. That’s enough to call over the radio and get the person out. IRIS identifies nobody: it sees that someone crossed a boundary, not who they are. And it stops nothing: who leaves, and when, is decided by a person.

What people usually ask

Does IRIS know who walked into the red zone?

No. IRIS sees that a person crossed the painted edge and how long they have been inside. It does not recognize faces and does not compare them with any list. The alert says one person inside the red enclosure, never a name. Who it was is worked out afterward, from the video and the work permit, and it’s a person who does that.

Who decides where the red zone is?

The plant does. The zone is drawn on the camera image, following the paint that’s already on the floor, and it is adjusted when the operation changes. IRIS doesn’t write the rule: it applies the one drawn for it. If the enclosure is open one day for authorized work, the rule is turned off for as long as that work lasts.

Does IRIS shut the equipment down when someone walks in?

No. IRIS alerts, it doesn’t act. It doesn’t close a valve, it doesn’t stop a pump and it doesn’t send anyone anywhere. What it does is put the camera, the time and the video of the moment in front of the control room. Deciding what to do remains a person’s job.

Other cameras